[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

[ATM] Coulter recoating

To: <atm@atmlist.net>
Subject: [ATM] Coulter recoating
From: "Jack Swaton @ Starry Host" <jswaton@starryhost.com>
Date: Wed, 13 Sep 2006 06:32:05 -0700
Delivered-to: atm_arc@astro.umsystem.edu
Importance: Normal
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
Sender: atm-bounces@atmlist.net

I have several 13.1" Coulter primaries and secondaries which need recoating.
I'm in the San Diego, CA area. Any suggestions on cost and where to go?
Should I have them refigured after they are tested by the vendor?
 
One mirror has hundreds of pin pricks and small areas of "see through". The
other is better coated but has a chip of 1 inch along an edge. In fact, I
also have a 10" Cave with a little see through and a2" scratch.
 
Thanks,
Jack
starryhost.com
_______________________________________________
ATM mailing list http://www.atmlist.net/

Prev by Author: Re: [ATM] Eyepieces
Next by Author: Re: [ATM] ATM Digest, Vol 33, Issue 13
Previous by thread: [ATM] Coating type.
Next by thread: [ATM] Dark finish for a telescope tube
Index(es):
- Author
- Thread