Re: [ATM] Making an exisiting mirror thinner

[hermit <hermit@outofoptions.org>]

Chris Todd wrote:
> At first blush, this sounds like it should be easy, but I'm guessing
> there are probably practical difficulties in pulling it off (e.g.,
> without getting grit on the polished front surface).  Then again, how
> long would it take to grind one inch of glass?
>
>   
Depending on the size of the mirror, this would be a lot of work and 
should only be undertaken if absolutely needed.  If the original blank 
was properly annealed, you 'probably' won't hurt the figure. 

Ken Lowther
_______________________________________________
ATM mailing list http://www.atmlist.net/