[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: ATM [Fwd: BOUNCE atm@shore.net: Non-member submission from [srychnov@uci.edu (Scott Rychnovsky)]]

To: Mel Bartels <mbartels@efn.org>
Subject: Re: ATM [Fwd: BOUNCE atm@shore.net: Non-member submission from [srychnov@uci.edu (Scott Rychnovsky)]]
From: Ken Lowther <s0109366@cc.ysu.edu>
Date: Thu, 26 Nov 1998 09:42:16 -0500 (EST)
cc: atm@shore.net
In-Reply-To: <365CF8E8.66DFFB44@efn.org>
Reply-To: Ken Lowther <s0109366@cc.ysu.edu>
Sender: owner-atm@shore.net


> > From: srychnov@uci.edu (Scott Rychnovsky)
> >
> > Hi Arthur,
> >
> > I made one of these first using these designs to get an 8 RPM table with an
> > 18 RPM overarm.  It worked but it was SLOW to polish.  If I had more

I have one at this speed.  I catch up on a lot of reading while it runs.
;)  The end result of a slow polishing stroke is worth the wait!

Ken Lowther  
s0109366@cc.ysu.edu
Youngstown, Ohio  USA

References:
- ATM [Fwd: BOUNCE atm@shore.net: Non-member submission from [srychnov@uci.edu (Scott Rychnovsky)]]
  - From: Mel Bartels <mbartels@efn.org>

Prev by Author: Re: ATM Grinding Machine Questions
Next by Author: ATM Startesting ,light source for artificial star?
Prev by thread: ATM [Fwd: BOUNCE atm@shore.net: Non-member submission from [srychnov@uci.edu (Scott Rychnovsky)]]
Next by thread: Re: ATM [Fwd: BOUNCE atm@shore.net: Non-member submission from [srychnov@uci.edu (Scott Rychnovsky)]]
Index(es):
- Author
- Thread