[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: ATM ...on homebuilt EQ mounts

To: Jim Piunti <jim_piunti@email.msn.com>
Subject: Re: ATM ...on homebuilt EQ mounts
From: Peter <kitgears@kitgear.com>
Date: Thu, 12 Nov 1998 21:37:44 -0500
CC: atm@shore.net
References: <008c01be0d31$09756640$d454fea9@jim>
Reply-To: Peter <kitgears@kitgear.com>
Sender: owner-atm@shore.net


Hi Jim,

You may want to try brazing the two together or simpler yet - Loctite
has a wonderful product 609 and 620 used to lock bearings and shafts
with a gap spacing up to 0.005". The product works so well that you
should not expect to take them apart again later.

Peter


-----------------------------------------------------------------
Manufacturer of Precision Gear Components and Drive Systems
http://www.kitgear.com

Follow-Ups:
- Re: ATM ...on homebuilt EQ mounts
  - From: gwoods@albany.net (Gary Woods)

References:
- ATM ...on homebuilt EQ mounts
  - From: "Jim Piunti" <jim_piunti@email.msn.com>

Prev by Author: Re: ATM Re: Foam Aluminum
Next by Author: ATM helium filled OTAs
Prev by thread: Re: ATM ...on homebuilt EQ mounts
Next by thread: Re: ATM ...on homebuilt EQ mounts
Index(es):
- Author
- Thread