[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Fwd: Pressing was Re: Oversize tools questions

Are your casting plaster disks for the lap? If so, how do you form it?
Thanks
Brian


On Sun, 26 Nov 2006, Mel Bartels wrote:

>> I'm curious on the methods for making the over sized pitch lap (set
>> up, pouring, initial forming etc).
>
>
> No difference at all!  It's just a pitch lap...  I worry a lot more about
> pressing the area directly under the mirror than the small bit that's
> outside the mirror diameter.
>
> Mel Bartels
>
>
> _______________________________________________
> ATM mailing list http://www.atmlist.net/
>
_______________________________________________
ATM mailing list http://www.atmlist.net/