[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Fwd: Pressing was Re: Oversize tools questions

To: <atm@atmlist.net>
Subject: Re: [ATM] Fwd: Pressing was Re: Oversize tools questions
From: "Mel Bartels" <mbartels@bbastrodesigns.com>
Date: Sun, 26 Nov 2006 16:22:11 -0800
Delivered-to: atm_arc@astro.umsystem.edu
Importance: Normal
In-reply-to: <5cf37e480611261209g7083ce0bsa36ce0a59ab277ca@mail.gmail.com>
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
Sender: atm-bounces@atmlist.net

> I'm curious on the methods for making the over sized pitch lap (set
> up, pouring, initial forming etc).


No difference at all!  It's just a pitch lap...  I worry a lot more about
pressing the area directly under the mirror than the small bit that's
outside the mirror diameter.

Mel Bartels


_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] Fwd: Pressing was Re: Oversize tools questions
  - From: "B. Bainbridge" <brianb@u.washington.edu>

References:
- [ATM] Fwd: Pressing was Re: Oversize tools questions
  - From: "Matthew Fuchs" <matthew.fuchs@gmail.com>

Prev by Author: Re: [ATM] Pressing was Re: Oversize tools questions
Next by Author: Re: [ATM] Pressing was Re: Oversize tools questions
Previous by thread: [ATM] Fwd: Pressing was Re: Oversize tools questions
Next by thread: Re: [ATM] Fwd: Pressing was Re: Oversize tools questions
Index(es):
- Author
- Thread