[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

[ATM] pitch tool

To: atm@atmlist.net
Subject: [ATM] pitch tool
From: horace r davis <hrd9@juno.com>
Date: Wed, 30 May 2007 19:47:56 -0400
Delivered-to: atm_arc@astro.umsystem.edu
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
Sender: atm-bounces@atmlist.net

the pitch tool pulled away along edge when making. Thinking of drilling
holes in edge of tool for finger grips so I don't touch the pitch.  re
heating tool in dryer and pressing with tool on top to make good contact.
I think because of the weight of mirror at 50 lb I will work with tool on
top I am not worried about focal length. will seen a picture to any one
who would to see it i would like your help. 125 hr of grinding done
_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] pitch tool
  - From: Dale Eason <atmpob@yahoo.com>

Prev by Author: [ATM] pitch lap
Next by Author: Re: [ATM] Is ATMing really disappearing?
Previous by thread: Re: [ATM] pitch tool
Next by thread: Re: [ATM] pitch tool
Index(es):
- Author
- Thread