[ATM] Beveling Pyrex or Plate glass

["Russell Jocoy" <russjocoy@hotmail.com>]

   Richard,     I have no experience beveling on a milling machine. I use a 
dremmel tool with a diamond coated grinding drum that is about 1/2" in 
diameter. The dremmel is mounted on a homemade jig that angles the cutting 
edge at 45 degrees. I have a small plastic tube (like the WD 40 straw) that 
shoots a water jet right to the diamond drum wheel. The dremmel rotates at 
variable RPM's and I have found that around  10,000 to 15,000 rpms works 
best. I just rotate the tool around the blank by hand , as you would a 
router. The bevels come out nice and there is no glass dust just white mud 
that is washed into the grassy ground to hook up with his brothers the sand 
particles....
                                   Russ Jocoy


_______________________________________________
ATM mailing list http://www.atmlist.net/