[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Difficulty Level of figuring 3/4 Plate Glass

To: <atm@atmlist.net>
Subject: Re: [ATM] Difficulty Level of figuring 3/4 Plate Glass
From: "Bob May" <bobmay@nethere.com>
Date: Wed, 10 May 2006 17:57:46 -0700
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <20060508235452.58672.qmail@web31402.mail.mud.yahoo.com> <44620D98.10101@uiuc.edu>
Sender: atm-bounces@atmlist.net

Just grinding the backs at 25 micron shoujld be enough as you
don['t need an optically flat surface and the two pieces of glass
should be fairly flat to begin with as float glass usually is.
Two or three wets of 25 micron shoujld end up with the glass
fully ground.
Bob May
bobmay at nethere.com
http: slash /nav.to slash bobmay
http: slash /bobmay dot astronomy.net
Replace the obvious words with the proper character.

_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] Difficulty Level of figuring 3/4 Plate Glass
  - From: COO <coo_mo@yahoo.com>
- Re: [ATM] Difficulty Level of figuring 3/4 Plate Glass
  - From: Mike Lockwood <melockwo@uiuc.edu>

Prev by Author: Re: [ATM] German Site
Next by Author: Re: [ATM] aluminum steel corrosion problem
Previous by thread: Re: [ATM] Difficulty Level of figuring 3/4 Plate Glass
Next by thread: [ATM] Difficulty Level of figuring 3/4 Plate Glass
Index(es):
- Author
- Thread