[ATM] ATM: Re., re., re: Ball Bearings

["David Harbour" <scarab2@cox.net>]

Jeff, all:

You are quite welcome- helping other atms rather than doing actual atm-ing
has become my hobby, now. (physical health has crashed, somewhat
permanently- no more glass pushin' for this old man)


http://www.atmsite.org/contrib/Harbour/Brngz.html




----- Original Message ----- 
From: "jeff dougherty" <ryslen@hotmail.com>
To: <scarab2@cox.net>
Sent: Sunday, May 15, 2005 7:30 PM
Subject: RE: Re., Ball bearings


> Dave,
> Thank you so much for supporting a fellow project man.
>
> Thanx
> Jeff Dougherty
>
> >From: "David Harbour" <scarab2@cox.net>
> >To: <Ryslen@hotmail.com>
> >Subject: Re., Ball bearings
> >Date: Sun, 15 May 2005 07:23:13 -0500
> >
> >Better than a ball bearing that size, Jeff, is to use little bitty
bearings
> >as rollers, mounted KINAMTICALLY. My largest bearing is not quite one
half
> >(actually, a little over one half) that size. Howwever, the good news is
> >that you don't need a bearing that size! Any rolling/support application
> >that would benefit from the use of a large bearing with axis sleeved
inside
> >it, will do fine if supported "kinematically" with five smaller ball
> >bearings as rollers. Go here, and read the article at the top of the
page,
> >before looking at the catalogue, and then you will understand that you
will
> >NEVER EVER NEED A LARGE BALL BEARING!:
> >
http://www.atmsite.org/contrib/Harbour/Brngz.html
> >
> >If you have any questions, email me again!
> >
> >Dave
>
> _________________________________________________________________
> FREE pop-up blocking with the new MSN Toolbar - get it now!
> http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/
>
>


_______________________________________________
ATM mailing list http://www.atmlist.net/