[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Flex Software

To: <atm@atmlist.net>
Subject: Re: [ATM] Flex Software
From: "Bob May" <bobmay@nethere.com>
Date: Sun, 15 May 2005 12:53:58 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <4287633E.7080104@rcn.com>
Sender: atm-bounces@atmlist.net

Suspect that the difference between Pyrex and plate glass isn't that big for
flexing.  The article, I think, also expects fine tuning due to inability to
get an accurate thickness as well as the change of thickness over the area
of the mirroro.
Bob May
bobmay@nethere.com
http://nav.to/bobmay
http://bobmay.astronomy.net

_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] Flex Software
  - From: "Bill Kelley" <flex@commspeed.net>

References:
- [ATM] Flex Software
  - From: "Richard F.L.R. Snashall" <rflrs@rcn.com>

Prev by Author: Re: [ATM] re: Cutting 3/4" Plate glass
Next by Author: Re: [ATM] LWT setup questions
Prev by thread: [ATM] Flex Software
Next by thread: Re: [ATM] Flex Software
Index(es):
- Author
- Thread