[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] re: Cutting 3/4" Plate glass

To: <atm@atmlist.net>
Subject: Re: [ATM] re: Cutting 3/4" Plate glass
From: "Bob May" <bobmay@nethere.com>
Date: Sat, 14 May 2005 14:28:29 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <42855196.3060600@pacbell.net> <428629D8.3010207@adelphia.net>
Sender: atm-bounces@atmlist.net

Pete, where did you buy the diamond blade?
There seems to be a lot of sources for diamond rotarty saw blades but not
many for bandsaw blades.  Worse yet is when you do a Google search, the
bandsaw blade stuff doesn't seem to appear.
Bob May
bobmay@nethere.com
http://nav.to/bobmay
http://bobmay.astronomy.net

_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] re: Cutting 3/4" Plate glass
  - From: Bill Marriott <bmarriott@pacbell.net>
- Re: [ATM] re: Cutting 3/4" Plate glass
  - From: Pete <lenses@adelphia.net>

Prev by Author: Re: [ATM] re: Cutting 3/4" Plate glass
Next by Author: Re: Hobby-Eberle Was Re: [ATM] ATM edge support
Prev by thread: Re: [ATM] re: Cutting 3/4" Plate glass
Next by thread: Re: [ATM] re: Cutting 3/4" Plate glass
Index(es):
- Author
- Thread