[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] re: Cutting 3/4" Plate glass

On Fri, 13 May 2005 18:17:10 -0700, you wrote:

	Hi Bill,

	I made a disk out of 3/4" plywood, 2 layers thick. Then put metal strapping around the edge, put a bolt in the
center then mounted that in my drill press at a medium RPM and cut through very nicely in about a half hr. with water
and grit (about #80 if I remember right) .
	Hope this helps.

		Jerry


>
>I would be very interested in how others have dealt with cutting plate 
>glass this thick.
>

_______________________________________________
ATM mailing list http://www.atmlist.net/