[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] re: Cutting 3/4" Plate glass

To: atm@atmlist.net
Subject: Re: [ATM] re: Cutting 3/4" Plate glass
From: Ken Lowther <hermit@outofoptions.org>
Date: Fri, 13 May 2005 21:45:19 -0400
In-Reply-To: <42855196.3060600@pacbell.net>
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <42855196.3060600@pacbell.net>
Sender: atm-bounces@atmlist.net
User-Agent: Internet Messaging Program (IMP) 4.1-cvs


Quoting Bill Marriott <bmarriott@pacbell.net>:

> "Just how big of a stable  mirror could one fabricate out of this glass"
>
> All comments greatly appreciated.
>

Dave Sopchak did an 18 with 7/8 inch thick glass.  I saw not problem 
with the mount not supporting it properly.  Ken

----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.

_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] re: Cutting 3/4" Plate glass
  - From: Bill Marriott <bmarriott@pacbell.net>

Prev by Author: Re: [ATM] looking for NEWT 2.5
Next by Author: Re: [ATM] RE:anealing
Prev by thread: [ATM] re: Cutting 3/4" Plate glass
Next by thread: Re: [ATM] re: Cutting 3/4" Plate glass
Index(es):
- Author
- Thread