[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Aluminium or stainless steel?

To: <atm@atmlist.net>
Subject: Re: [ATM] Aluminium or stainless steel?
From: "Bob May" <bobmay@nethere.com>
Date: Sat, 7 May 2005 13:11:20 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <20050507055658.E8D2D71CDE@mail.netspace.net.au>
Sender: atm-bounces@atmlist.net

I'll also note that the 500mm (a foot and a half) is a bit far as this will
cause a long springing distance that isn't going to make things easy.
Better to figure out ways to get that distance down to something as short as
possible.
Bob May
bobmay@nethere.com
http://nav.to/bobmay
http://bobmay.astronomy.net

_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] Aluminium or stainless steel?
  - From: Woodchuck <djv@bedford.net>

References:
- [ATM] Aluminium or stainless steel?
  - From: "Gary McKenzie" <garymck@netspace.net.au>

Prev by Author: Re: [ATM] Constraints on design
Next by Author: Re: [ATM] Aluminium or stainless steel?
Prev by thread: Re: [ATM] Aluminium or stainless steel?
Next by thread: Re: [ATM] Aluminium or stainless steel?
Index(es):
- Author
- Thread