[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] sonotube coating

To: "atml" <atm@atmlist.net>
Subject: Re: [ATM] sonotube coating
From: "Bob May" <bobmay@nethere.com>
Date: Sat, 22 May 2004 16:05:25 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <003301c43fff$fcb44720$ff67fea9@ev1.net>
Sender: atm-bounces@atmlist.net

All you would gain is abrasion resistance.  Bump resistance won't change
from the basic cardboard form tube capabilities.
The bed liner plastic rubber is soft but resistant to scratching so it will
pass through any real bumps to the underlying substrate after cushioning the
point of the blow.
Bob May
http://nav.to/bobmay
bobmay@nethere.com
NEW! http://bobmay.astronomy.net


_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] sonotube coating
  - From: "Jerry B. Hillman" <JBHillman@ev1.net>

Prev by Author: Re: [ATM] star testing
Next by Author: Re: [ATM] Pyrex Pie Plate primary
Prev by thread: [ATM] sonotube coating
Next by thread: Re: [ATM] sonotube coating
Index(es):
- Author
- Thread