[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] when to go to a pitch lap

To: "atml" <atm@atmlist.net>
Subject: Re: [ATM] when to go to a pitch lap
From: "Bob May" <bobmay@nethere.com>
Date: Wed, 19 May 2004 10:40:02 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <001001c43dac$b2b126c0$92cfe504@yourm5d4u9r2uv>
Sender: atm-bounces@atmlist.net

Something in the 12 to 5 micron range for Aluminum Oxide is a good point to
start polishing the glass.
I'd suggest that when you make the lap, you don't make it any larger than
about 16" or it will be extremely hard to push about on the mirror.
Bob May
http://nav.to/bobmay
bobmay@nethere.com
NEW! http://bobmay.astronomy.net


_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] when to go to a pitch lap
  - From: "David Williams" <dwilliams1128@earthlink.net>

Prev by Author: Re: [ATM] Re: Fw: Hello at ATM list
Next by Author: Re: [ATM] First project
Prev by thread: [ATM] when to go to a pitch lap
Next by thread: Re: [ATM] when to go to a pitch lap
Index(es):
- Author
- Thread