Re: [ATM] Two questions on collimation bolts

["Don Clement" <clement.focuser@verizon.net>]

Same as what?

Don


> Dumb question, would a nylon bolt do the same?
>
> Rod
>
>
>
>
> > An easy way to make a solid machined flexure using the collimation bolt
> > itself is to make four cuts in the middle  section of the bolt. Two  of
> > the
> > cuts would leave a thin rectangular cross section. A similar rectangular
> > cross section could be made  perpendicular to the first. The cuts could
be
> > made with a hack saw. This would allow  bending of the bolt for a small
> > tilt-tip angular movement but would be rigid in the axial direction.
> >
> > Don Clement
> > Running Springs, California
> >
> > _______________________________________________
> > ATM mailing list http://www.atmlist.net/
> >
>
>

_______________________________________________
ATM mailing list http://www.atmlist.net/