[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: [ATM] Two questions on collimation bolts
An easy way to make a solid machined flexure using the collimation bolt
itself is to make four cuts in the middle section of the bolt. Two of the
cuts would leave a thin rectangular cross section. A similar rectangular
cross section could be made perpendicular to the first. The cuts could be
made with a hack saw. This would allow bending of the bolt for a small
tilt-tip angular movement but would be rigid in the axial direction.
Don Clement
Running Springs, California
_______________________________________________
ATM mailing list http://www.atmlist.net/