Re: [ATM] pitch tool

["Bob May" <rmay@nethere.com>]

Generally, if you do a cool pouring or pressing of the pitch to
the tool, you can often get a failure to bond at the edge where
things are the ccoolest.  This will cause the edge of the lap to
flex and thus make a somewhat subdiameter lap.  The only solution
is to reheat the lap and insure that the edges get into contact
and adheared to the  tool.  Turps or something like that will
assist in getting a good joint.
Bob May
Due to the large volume of SPAM thaat I'm getting, add an open
square bracket to the subject line or my spam filter will reject
your post~
rmay at nethere.com
http: slash /nav.to slash bobmay
http: slash /bobmay dot astronomy.net
Replace the obvious words with the proper character.

_______________________________________________
ATM mailing list http://www.atmlist.net/