[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Stroke

To: "atmlist" <atm@atmlist.net>
Subject: Re: [ATM] Stroke
From: "Bob May" <bobmay@nethere.com>
Date: Thu, 24 Jun 2004 09:41:43 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <55413231054.20040623220433@mn.rr.com>
Sender: atm-bounces@atmlist.net

Do your first work with the tool on top so as to opent the radius a bit.  If
the generation is fairly clean then I'd start with 220 or even 320 grit and
only go to 120 if 2 wets don't take the grinding marks out of the surface.
Remember that which ever is on top tends to go concave!
Bob May
http://nav.to/bobmay
bobmay@nethere.com
NEW! http://bobmay.astronomy.net


_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] Stroke
  - From: Paul Johnson <bigatm@mn.rr.com>

Prev by Author: Re: [ATM] Trepanning 101
Next by Author: Re: [ATM] Turned edge - back to fine grinding?
Prev by thread: RE: [ATM] Stroke
Next by thread: Re: [ATM] Suction cups
Index(es):
- Author
- Thread