[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

[ATM] Stroke

To: atm@atmlist.net
Subject: [ATM] Stroke
From: Paul Johnson <bigatm@mn.rr.com>
Date: Wed, 23 Jun 2004 22:04:33 -0500
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
Reply-To: Big ATM <bigatm@mn.rr.com>
Sender: atm-bounces@atmlist.net


I'm a n00b who's been watching this list for about two weeks.  I'm ready to start grinding my 10" plate glass.  I ordered it pre-generated to f6 and the guy marked it f5.8 with a black sharpie.  

Question.  If my goal is to grind it to f6 using #80 grit, is it best to use a 1/3 COC stroke?  All comments welcome.

Thanks,

Paul Johnson
St. Paul, Minnesota USA
9:53 PM (UTC -5)

_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] Stroke
  - From: "Bob May" <bobmay@nethere.com>
- RE: [ATM] Stroke
  - From: "Ellen Mackenzie" <mackenzieconsulting@sympatico.ca>
- Re: [ATM] Stroke
  - From: hermit <hermit@outofoptions.com>

Prev by Author: Re: [ATM] First Lap Tips - THANKS!
Next by Author: Re: [ATM] Turned edge - back to fine grinding?
Prev by thread: Re: [ATM] sticking it
Next by thread: Re: [ATM] Stroke
Index(es):
- Author
- Thread