[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

[ATM] Machining

To: <atm@atmlist.net>
Subject: [ATM] Machining
From: "Jacob Lauser" <sirius@riverstyx.com>
Date: Thu, 17 Jun 2004 17:26:45 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
Sender: atm-bounces@atmlist.net

Hey, folks! I'm new here, but not new to ATMing. I was wondering if any had leads on fairly-priced machinists? I'm getting outrageous quotes from the locals because they're too used to dealing with the University at exhorbitant prices. I just have a couple medium-sized pieces in 1/2" aluminum to be done. Any leads would help...

- Jake Lauser
Tucson, Arizona
_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] Machining
  - From: "Bob May" <bobmay@nethere.com>
- Re: [ATM] Machining
  - From: Ken Lowther <hermit@outofoptions.org>
- Re: [ATM] Machining
  - From: "matt" <mariusrf@bellsouth.net>

Prev by Author: [ATM] Fine scratches during polishing - Cures?
Next by Author: [ATM] BVC
Prev by thread: Re: [ATM] Lost tiles on tool. Need advice.
Next by thread: Re: [ATM] Machining
Index(es):
- Author
- Thread