[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] First Pitch Lap - any tips?

To: "atml" <atm@atmlist.net>
Subject: Re: [ATM] First Pitch Lap - any tips?
From: "Bob May" <bobmay@nethere.com>
Date: Thu, 10 Jun 2004 09:29:26 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <40c77fa7.3bb.50d6.1997534563@netreach.net><1172.64.28.53.17.1086819023.squirrel@webmail.peak.org>
Sender: atm-bounces@atmlist.net

I actually haven't been making a edge to the lap lately but rather just
pouring the pitch in the center of the tool and pressing out with a mold
between until (hopefully) the pitch gets to the edge of the tool.  If the
pitch goes off in one area, I just snap it off and keep on going.
Bob May
http://nav.to/bobmay
bobmay@nethere.com
NEW! http://bobmay.astronomy.net


_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- Re: [ATM] First Pitch Lap - any tips?
  - From: matt@considine.net
- Re: [ATM] First Pitch Lap - any tips?
  - From: vorblesnak@peak.org

Prev by Author: Re: [ATM] First Pitch Lap - any tips?
Next by Author: Re: [ATM] First Pitch Lap - any tips?
Prev by thread: Re: [ATM] First Pitch Lap - any tips?
Next by thread: Re: [ATM] First Pitch Lap - any tips?
Index(es):
- Author
- Thread