[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

[ATM] Need help with Figuring

To: "ATM List" <atm@atmlist.net>
Subject: [ATM] Need help with Figuring
From: "Rich Ball" <ShooterBall@hotmail.com>
Date: Mon, 7 Jun 2004 05:11:05 -0500
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
Reply-To: Rich Ball <ShooterBall@hotmail.com>
Sender: atm-bounces@atmlist.net


I have an 8" f8 project in the figuring stage of life.  But I went too deep and am now trying to regain a spherical configuration.  I also had developed a turned down edge.

I have been working on the pitch lap, after hot pressing, MOT with short strokes, mostly center over center but some W too.  Strokes are less than 3" of movement.

I seem to be going the right direction but I am not sure I am correcting the TDE.  

How should I do this?

Gratefully,

Richard Ball
_______________________________________________
ATM mailing list http://www.atmlist.net/

Prev by Author: [ATM] back to sphere
Next by Author: [ATM] Please help me figure?
Prev by thread: Re: [ATM] Nasmyth secondary mirror cell
Next by thread: [ATM] New ATM swap list
Index(es):
- Author
- Thread