[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: ATM cutting pyrex

To: Abaknon@aol.com
Subject: Re: ATM cutting pyrex
From: Tim Walters <trwalters@mindspring.com>
Date: Mon, 05 Jul 1999 22:12:23 -0400
CC: atm@shore.net
References: <90c5d5e9.24b03af0@aol.com>
Reply-To: Tim Walters <trwalters@mindspring.com>
Sender: owner-atm@shore.net


Hi Paulo,

Abaknon@aol.com wrote:
I've read quite a few posts on cutting plate glass...

The best cuts I've seen are with an abrasive water-jet cutting system. I have
all my blanks cut that way and it does a GREAT job. There isn't any difference
in plate and Pyrex with this method. If you can find one of these businesses
close to you, it would be worth your time and money to check it out.

Tim

--
Tim Walters, Atlanta, GA
trwalters@mindspring.com

** 1" Plate Glass Mirror Blanks **

Astronomy Site: http://www.mindspring.com/~trwalters
*** UPDATED 6/15/99 ***

References:
- ATM cutting pyrex
  - From: Abaknon@aol.com

Prev by Author: ATM Re: Welcome and Orientation For Newbies
Next by Author: ATM Re: SCT mirror flop - how about shims?
Prev by thread: ATM cutting pyrex
Next by thread: ATM Daisy Sight Conversion Project
Index(es):
- Author
- Thread