Re: [ATM] Milling About

["Adam Smith" <ajus@csolve.net>]

Just a small correction to my earlier post:

The CNC group that does tolerate a bit of off topic is 
DIY-CNC@yahoogroups.com. Good group there, including one ATM who has done 
truly amazing observatory motion control system.

----- Original Message ----- 
From: "Adam Smith" <ajus@csolve.net>
To: "Anthony Stillman" <atm@atmlist.net>
Sent: Saturday, July 01, 2006 12:19 PM
Subject: Re: [ATM] Milling About


> The resources I use most are two usenet groups: rec.crafts.metalworking 
> and
> uk.rec.models.engineering. For CNC information I use a yahoo group: 
> DIYCNC.

<snip>

> Regards to all,
>
> Adam Smith
> Midland, ON
>
>
> ----- Original Message ----- 
> From: "Richard" <cnc@cncservo.co.uk>
> To: "Anthony Stillman" <atm@atmlist.net>
> Sent: Saturday, July 01, 2006 8:12 AM
> Subject: Re: [ATM] Milling About
>
>
>> Hi Anthony,
>>
>> Saturday, July 1, 2006, 6:54:34 AM, you wrote:
>>
>> AS> I need advice and directions
>>
>> You will get sound advice if you ask on the model engineers
>> mailing list. Join here :
>> http://www.kepler-eng.com/lists
>>
>>
>> -- 
>>
>> Best regards,
>>  Richard in the UK
>>

_______________________________________________
ATM mailing list http://www.atmlist.net/