[ATM] Milling About

[Anthony Stillman <atmer@flash.net>]

I need advice and directions, help actually.  And I?m
treading a fine line with this post.

I?m looking for  the people who are to milling as ATMs
are to ATMing.  I?ve googled and surfed for the
requisite hours and found a few enthusiast?s sites,
some incredibly large astoundingly precise and
unbelievable expensive machines, and almost not at all
any of what I was hoping for, or expected.  I know   y
o u    p e o p l e   are out there, and there must be
machines that are neither toys nor need a factory
floor to stand their weight, but I can hardly see you
or them through the netting.  I?d appreciate links. 
And if they are to enthusiast?s sites, I think the
list would too.


Anthony

amicus curiae
Friend of the court.

_______________________________________________
ATM mailing list http://www.atmlist.net/