[ATM] 12.5 inches BVC mirror update - new photos

["RM L" <atm@axeinformatique.com>]

After polishing MOT with the stroke that Bob May suggested,
(a total stroke length of about 3" and a W of about 2")...

I put some new photos on my page : http://www.axeinformatique.com/temp/Mirror/BVC_Mirror.html

It seems to have had little effect.The outer portion may have changed a bit, i'm not shure. I'm not shure if the TDE changed either.

I pressed my lap 5 minutes with onion bag, then pressed another 20-30 minutes, and I did a few shorter pressings during sessions,
when I felt that the lap was grabbing and slipping.

I did two sessions of 20-25 minutes, and one shorter of 10 minutes (the first session, I wanted to test before continuing).

So, a total of about 55 minutes.

Contact seemed good. Had to push hard, and feeling is like Bob says, (like there is grease between the two surfaces that allows for a hard slow pull without easy
sliding.)

What stroke should I use now, for how long, am I doing something wrong, etc ???

Thanks all,
RML
_______________________________________________
ATM mailing list http://www.atmlist.net/