[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Turned Down Edge

To: "ATM List" <atm@atmlist.net>
Subject: Re: [ATM] Turned Down Edge
From: "Mel Bartels" <mbartels@bbastrodesigns.com>
Date: Thu, 15 Jul 2004 22:41:26 -0700
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <20040715165853.11415.qmail@web52702.mail.yahoo.com><BAY16-DAV6FSeXOfFdh00045fa8@hotmail.com><014d01c46af4$d2cea8e0$3802a8c0@jon>
Sender: atm-bounces@atmlist.net

> I think it would be difficult to produce the narrow severe TDE I did by
> polishing the mirror everywhere but the outer 1/4"!

On the contrary, I see this all the time.  People bevel their laps and use
very straight strokes, or the outside edge of their laps sink.  Results in a
narrow turned edge, oh, 1/8 inch in extent.

Mel Bartels

_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- Re: [ATM] Turned Down Edge
  - From: Ken Hunter <atm_ken_hunter@yahoo.com>
- Re: [ATM] Turned Down Edge
  - From: "Rich Ball" <ShooterBall@hotmail.com>
- Re: [ATM] Turned Down Edge
  - From: "Jonathan Bishop" <jonathan_bishop@sbcglobal.net>

Prev by Author: Re: [ATM] Re:How much of cell induced deformation is too much?
Next by Author: Re: [ATM] Mirror cell
Prev by thread: Re: [ATM] Turned Down Edge
Next by thread: Re: [ATM] Turned Down Edge
Index(es):
- Author
- Thread