Re: [ATM] PLOP Calculations

["Arjan te Marvelde" <arjan.te.marvelde@hetnet.nl>]

This might cause a lateral force component on the mirror edge, which you
just tried to avoid using bearings or teflon coating. The lateral force
could have worse effect than the displacement frm COG?
/Arjan


----- Original Message ----- 
From: "Ken Hunter" <atm_ken_hunter@yahoo.com>
To: "Nils Olof Carlin" <nilsolof.carlin@telia.com>; "Arjan te Marvelde"
<arjan.te.marvelde@hetnet.nl>; <atm@atmlist.net>
Sent: Tuesday, 06 July, 2004 20:36
Subject: Re: [ATM] PLOP Calculations


> --- Nils Olof Carlin <nilsolof.carlin@telia.com>
> wrote:
>
> > it may be wise to make a clamp, or use tape, at a
> > few points to define the level better.
> >
> > Nils Olof
> >
> > _______________________________________________
> > ATM mailing list http://www.atmlist.net/
> >
>
>
> When you have the blank on the turntable and are
> generating the curve, why not "machine" in a groove
> around the blank to locate the cable?
>
> Ken Hunter
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Mail - 50x more storage than other providers!
> http://promotions.yahoo.com/new_mail

_______________________________________________
ATM mailing list http://www.atmlist.net/