Re: [ATM] Material for Tool

[Jeff Lowe <lowe@nanotechsys.com>]

From: Mark Holm <mdholm@telerama.com>
> Subject: Re: [ATM] Material for Tool
>
> There are a bunch of reasons to skip the epoxy, including the fact that 
> the method described here is cheaper.
> http://gotgrit.com/make_tool7.php
> Pictures are here
> http://gotgrit.com/make_tool1.php
>
> I suspect this is the method Bob May uses to get the job done in an hour 
> or less.
Thanks Mark. The pictures on the first page show exactly why I use 
epoxy. On the left hand side of the tool shown are numerous holes where 
grit will get trapped. For me it has a way of waiting until I am at 5u 
before falling back out. The sealing of the channels and the smooth 
filleting of epoxy is reason enough for me to use it.
_______________________________________________
ATM mailing list http://www.atmlist.net/