[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Material for Tool

To: atm@atmlist.net
Subject: Re: [ATM] Material for Tool
From: Mark Holm <mdholm@telerama.com>
Date: Sun, 13 Jan 2008 17:34:19 -0500
Delivered-to: atm_arc@astro.umsystem.edu
In-reply-to: <4A58AC4C.4010302@nanotechsys.com>
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <mailman.1.1200020400.19150.atm@atmlist.net> <4A58AC4C.4010302@nanotechsys.com>
Sender: atm-bounces@atmlist.net
User-agent: Thunderbird 2.0.0.9 (Windows/20071031)

There are a bunch of reasons to skip the epoxy, including the fact that 
the method described here is cheaper.

http://gotgrit.com/make_tool7.php

Pictures are here

http://gotgrit.com/make_tool1.php

I suspect this is the method Bob May uses to get the job done in an hour 
or less.

-- 
Mark Holm
mdholm@telerama.com

_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] Material for Tool
  - From: "Bob May" <rmay@nethere.com>

References:
- Re: [ATM] Material for Tool
  - From: Jeff Lowe <lowe@nanotechsys.com>

Prev by Author: Re: [ATM] Microwave heating of glass
Next by Author: Re: [ATM] mirror pinching
Previous by thread: Re: [ATM] Material for Tool
Next by thread: Re: [ATM] Material for Tool
Index(es):
- Author
- Thread