[ATM] Grinding plate

[Jerry Dove <jldove1@cableone.net>]

	Hi again,

	I've made a new 2" thick support for my slumped mirror.  

	 I had made a full size grinding tool (2" x 9") with 1"x1"x 3/8" ceramic floor tiles epoxied onto it. The tool
and blank seem to be well mated together at this point. Can I continue with the grinding ( I think I'm at 220 ) using
this or should I make a new tool with porcelain tiles. There seems to be plenty of tile left to finish grinding, but
will tile pieces break off into larger pieces than the grit I'm grinding with and cause problems?

	I have a wooden tool ( 3 Layers of 3/4" x 7" ) that I was going to use for the pitch polishing and figuring if
the group thinks it will work OK.

	Thanks again,

	Jerry Dove
	Kuna, ID.
_______________________________________________
ATM mailing list http://www.atmlist.net/