[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Re: ATM Digest, Vol 13, Issue 7

To: <atm@atmlist.net>
Subject: Re: [ATM] Re: ATM Digest, Vol 13, Issue 7
From: "Bob May" <bobmay@nethere.com>
Date: Wed, 5 Jan 2005 17:09:22 -0800
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <200501050300.j0530hnh048600@b.mail.peak.org><1199.159.121.96.164.1104938950.squirrel@159.121.96.164>
Sender: atm-bounces@atmlist.net

Yep, that's another name for them.  I have used one for rolling 1" solid
aluminum structural stock and they work very nicely for the job when the
stock fits the wheels.  I could roll a piece within 1% of the proper
diameter after adjusting the third roller to the right position for the
bending desired.
Bob May
bobmay@nethere.com
http://nav.to/bobmay
http://bobmay.astronomy.net

_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] Re: ATM Digest, Vol 13, Issue 7
  - From: vorblesnak@peak.org

Prev by Author: Re: [ATM] bending square aluminium tube
Next by Author: Re: [ATM] bending square aluminium tube
Prev by thread: [ATM] Re: ATM Digest, Vol 13, Issue 7
Next by thread: [ATM] Re: ATM Digest, Vol 13, Issue 8
Index(es):
- Author
- Thread