[ATM] Re: ATM Digest, Vol 13, Issue 7

[vorblesnak@peak.org]

What Bob is speaking of is an arc roller.  A simple one is discribed in
The Mother Earth News, back in the late 80's.  Made out of lawn mower
wheels as I recall.  I made one using small bicycle wheels, worked for
what I wanted.

David Davis
Toledo, OR  97391

>
> Message: 2
> Date: Tue, 4 Jan 2005 17:51:56 -0800
> From: "Bob May" <bobmay@nethere.com>
> Subject: Re: [ATM] bending square aluminium tube
> To: <atm@atmlist.net>
> Message-ID: <004201c4f2c9$23f19640$1600a8c0@amd>
> Content-Type: text/plain;	charset="iso-8859-1"
>
> Next time you may want to investigate the 3 wheel type bender for the
> tubing.  Two stationary wheels on one side and a movable one on the other
> side all with a form on the edge to hole the tubing in place.   The thing
> that is nice about this method is that it can be done slowly if so desired
> and get to the diameter that is desired by repeated runs through the set
> of
> dies or wheels.
> Bob May
> bobmay@nethere.com
> http://nav.to/bobmay
> http://bobmay.astronomy.net
>
>
>
> ------------------------------
>
> _______________________________________________
> ATM mailing list http://www.atmlist.net/
>
> End of ATM Digest, Vol 13, Issue 7
> **********************************
>


_______________________________________________
ATM mailing list http://www.atmlist.net/