[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

[ATM] bending square aluminium tube

To: <atm@atmlist.net>, <Make_Your_Own_Telescope@yahoogroups.com>, <atm_free@yahoogroups.com>
Subject: [ATM] bending square aluminium tube
From: "Jan van Gastel" <jhm.vangastel@wanadoo.nl>
Date: Tue, 4 Jan 2005 11:27:57 +0100
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <HNEXFE07wEsGmjm08Iy00034d1e@hnexfe07.hetnet.nl><001501c4de33$b9e816b0$0301a8c0@Acer>
Sender: atm-bounces@atmlist.net

I have added a webpage about bending aluminium square tubing into a ring,
with a wooden jig and a vice. Last weekend, I bent a secondary ring for a
lightweight 12 inch scope I am building. It worked out very well. The page
can be foud at:
http://home.wanadoo.nl/jhm.vangastel/Astronomy/50cmscope/bending.htm


Jan
http://home.wanadoo.nl/jhm.vangastel/Astronomy/

_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] bending square aluminium tube
  - From: "Bob May" <bobmay@nethere.com>
- Re: [ATM] bending square aluminium tube
  - From: Richard Ozer <rozer@pacbell.net>

Prev by Author: [ATM] Lerch's Robo Foucault VS. Interferometry, revisited
Next by Author: Re: [ATM] bending square aluminium tube
Prev by thread: Re: [ATM] bending rods
Next by thread: Re: [ATM] bending square aluminium tube
Index(es):
- Author
- Thread