Re: [ATM] Argh! How do I fix this?

[Dave and Connie <dmatt@frontiernet.net>]

I was thinking about that too.  My conclusion was that I could use an Xacto 
knife to pick off the pimple and ignore the small hole that it left.  It is 
certainly a lot smaller than a channel.

Dave


At 06:28 PM 2/23/2008, Mark Holm wrote:


>I've got a question.
>
>Say Dave ignores the chips, finishes 9 micron and goes to polishing.  When 
>he presses his lap, the chips will leave high
>spots on the lap.  Not large of course, but there all the same.  These 
>will cause accentuated local pressure.  For long
>polishing spells, they will get worn down and the effect won't be large, 
>but during figuring, with short spells, the
>effect may be roughness and a tendency toward turned edge.
>
>Anybody think I am, at least in principle, correct?
>
>--
>Mark Holm
>markholm@verizon.net
>
>_______________________________________________
>ATM mailing list http://www.atmlist.net/
>
>
>
>--

_______________________________________________
ATM mailing list http://www.atmlist.net/