Re: [ATM] Hyperbola? Warm pitch strikes again...

["Anthony Anconetani" <anthony.anconetani.atm@gmail.com>]

Hi all,

(Note: Zonal readings are in inches).

To the expert figurers: Last fall I had some trouble fixing a deep hole
([Z1:Z2:Z3]  = [0.000,0.040,0.040], in the center of my 6F6. I started by
trying to fix the hole by ONLY applying 1/3 COC TOT. After about 12 10min
sessions I was still stuck with a wide hole [0.000,0.030, 0.090]. I switched
to an ALTERNATING MOT/TOT 1/3 COC and made much quicker progress. For
example I made it to [0.000,0.019,0.040] in 4 10min sessions.

Is it possible that Scope Builder should alternate MOT and TOT to speed up
the process of returning to sphere?

-Anthony



On Feb 6, 2008 9:36 AM, Dale Eason <atmpob@yahoo.com> wrote:

> Feed the measurments into Sixtests or FrigureXP.
>
> Dale Eason
> --- Scope Builder <scopebuilder@gmail.com> wrote:
>
> > Question 2)  I know curiosity killed the cat, but
> > I'll ask this anyway.  I'm curious how many waves
> > I'm off.  How would you calculate wave error for
> > this?
> >
> > Thanks!
> > _______________________________________________
> > ATM mailing list http://www.atmlist.net/
> >
>
>
>
>
>  ____________________________________________________________________________________
> Looking for last minute shopping deals?
> Find them fast with Yahoo! Search.
> http://tools.search.yahoo.com/newsearch/category.php?category=shopping
> _______________________________________________
> ATM mailing list http://www.atmlist.net/
>
_______________________________________________
ATM mailing list http://www.atmlist.net/