Re: [ATM] Another machining question, please

["Don Clement" <don_clement@charter.net>]

I was wrong to suggest that anyone else use gloves when holding HSS bits
while grinding.
I normally hold a HSS lathe bit in a quick change toolholder while grinding.
Round items I hold in a small 5C collet block holder or ER20 collet holder
when grinding. I do sometimes wear gloves when grinding, but caution others
not  to do so and if one does wear gloves do so at one's own risk.

Don Clement
Running Springs, California


> DO NOT wear gloves, a very dangerous thing one can do.
> Mount the tool, hold it with something.
> Wearing something that can get caught in rotating machinery causes
accidents and body parts to get removed!
>
> Peter Nance, Jr.
> lenses@adelphia.net
>
>
> ---- Don Clement <don_clement@charter.net> wrote:
> >  I found it is best to mount the bit in a  tool
> > holder or wear gloves.
> >
> >
> >
> > Don Clement
> >
> > Running Springs, California
> >
> > >
> > > Other than take it slow when grinding, don't push too hard, > >
> >
> > _______________________________________________
> > ATM mailing list http://www.atmlist.net/
>
> _______________________________________________
> ATM mailing list http://www.atmlist.net/
>

_______________________________________________
ATM mailing list http://www.atmlist.net/