[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Another machining question, please

To: atm@atmlist.net
Subject: Re: [ATM] Another machining question, please
From: Thomas A Simmons <tasimmons@raytheon.com>
Date: Fri, 16 Feb 2007 06:46:46 -0700
Delivered-to: atm_arc@astro.umsystem.edu
In-reply-to: <20070215.144957.3212.0.jkoptic@juno.com>
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
Sender: atm-bounces@atmlist.net
Sensitivity:

WOW! Thanks, guys.


What is evident is the breath of experience on this board! and how many
tools


that are out there to do the same job. Thanks for opening my eyes to
Counterbores


and how to modify a drill bit to grind (??) the bottom flat.





Evidently, I don't have enough tools (VERY big laugh).





Tom
Too stubborn to quit being an ATMer



_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] Another machining question, please
  - From: "Thomas Janstrom" <thomas@moiler.com>

References:
- Re: [ATM] Another machining question, please
  - From: Jarvis Krumbein <jkoptic@juno.com>

Prev by Author: [ATM] Another machining question, please
Next by Author: Re: [ATM] ATM making flats
Previous by thread: Re: [ATM] Another machining question, please
Next by thread: Re: [ATM] Another machining question, please
Index(es):
- Author
- Thread