Re: Fwd: [ATM] Open Question Concerning Pitch Laps

[Ken Lowther <hermit@outofoptions.org>]

Quoting Bryan Stiles <bryan.stiles@gmail.com>:

> I did not scrape or brush the lap. Is there some guideline I should
> use to recognize when to do this? Now at the outset I didn't wash the
> lap off after use. Eventually the CeO mix built up and I used a soft
> brush to remove that and generally clean it up a bit. I should also
> mention that when not in use I store the lap in a plastic, sealed
> container.
>
Well, when the lap start not to work, that is an indication you may 
need to rough up the surface and brush away the embedded glass and 
polish. I once had a lap that moved like 'silk'.  Nice feel but was 
doing nothing. ;-)  You should still feel the drag.  I meant to say "Is 
your lap too thin?".  That will affect it also.

Ken

----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.

_______________________________________________
ATM mailing list http://www.atmlist.net/