[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] soldering SMPs

To: "ATM Superheros" <atm@atmlist.net>
Subject: Re: [ATM] soldering SMPs
From: "Don Clement" <don_clement@charter.net>
Date: Thu, 13 Dec 2007 08:21:02 -0800
Delivered-to: atm_arc@astro.umsystem.edu
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <Pine.LNX.4.44.0712131609410.7475-100000@uno.canit.se>
Sender: atm-bounces@atmlist.net

Hot air gun works best and the pads must be tinned and fluxed before.  Ideal
conditions are that  all the SMP device leads "float" on the solder pads and
the self-align inplace. You can solder individual leads with a controlled
small tip soldering iron but be sure to tin the pads first. Clean the flux
off after soldering.

Don Clement
Running Springs, California

>
> Anyone here have experience with soldering very small SMP
> devices? Solder points are 1.5 mm apart.
>
> Dominic
>

_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] soldering SMPs
  - From: Dominic-Luc Webb <dlwebb@canit.se>

Prev by Author: Re: [ATM] Bearing brakes
Next by Author: Re: [ATM] soldering SMPs
Previous by thread: Re: [ATM] soldering SMPs
Next by thread: Re: [ATM] soldering SMPs
Index(es):
- Author
- Thread