Re: [ATM] Lap question

["Polk, Tom" <TPolk@decatur-al.gov>]

Hey Dan,

If it were me, I would wire brush it, warm the lap a bit and press with
fiberglass window screen or wedding veil or citrus fruit netting (this
will help keep from trapping air in the "indentations"), wire brush
again then press until you have good contact... then polish to your
heart's content. 

Good luck!

Tom Polk
	

-----Original Message-----
From: atm-bounces@atmlist.net [mailto:atm-bounces@atmlist.net] On Behalf
Of Dan Lago
Sent: Thursday, December 06, 2007 12:00 PM
To: atm@atmlist.net
Subject: [ATM] Lap question

I have a lap that has been stored for a few months that I am ready to
start using again, but I noticed that a few facets have ~1/8"
indentations from the wrinkled aluminum foil that was covering it (it
gets fairly warm in my house during the summer).  I am done polishing
and working on figuring the mirror.  I think that the indentations are
too deep to press out.  Should I be concerned about these deformities?


Dan

_______________________________________________
ATM mailing list http://www.atmlist.net/
_______________________________________________
ATM mailing list http://www.atmlist.net/