[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

[ATM] mirror grinding

To: <atm@atmlist.net>
Subject: [ATM] mirror grinding
From: "ccabar" <ccabar@bigpond.com>
Date: Thu, 8 Dec 2005 18:57:53 +1100
List-Archive: <http://www.atmlist.net/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
Sender: atm-bounces@atmlist.net

Hi guys I'm grinding a 10 inch F6 Pyrex mirror using a tiled tool and my concern is that the mirror is grinding unevenly. There is at least 1/2mm difference between the lowest and the highest side. I have already ground 2mm and have 1/2 a mm to go. Should I press harder on the side that is higher or continue as is and will this affect the mirror in any way. I'm using 60 grit at the moment.

Regards Cristian 
_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] mirror grinding
  - From: "Bob May" <bobmay@nethere.com>

Prev by Author: Re: [ATM] Flat grinding the back of the primary mirror
Next by Author: Re: [ATM] Only two books allowed
Prev by thread: Re: [ATM] Mirror Cells - Springs vs. Push/Pull
Next by thread: Re: [ATM] mirror grinding
Index(es):
- Author
- Thread