Re: ATM Advice re: tube rings

[Brad Davy <bdavy@bigdog.fred.net>]

At 04:04 PM 8/2/97 -0500, Kyle Barger wrote:
>diameter.  I have so far succeeded in cutting rings with inside diameters
>that are too small, or too large, but the base interferes with placing a
Cut the inside diameter slightly small and then use a sander (I found a
Dremel to be invaluable) to finish the job.  Or sink the pivot nail far
enough in that it doesn't interfere with the router.

Option 3, use a compass to draw the circle and then a jig saw to cut it,
using a sander to finish the job.  For tube rings, the exact fit is not
really critical.  You can afford to be a wavelength or two off. :-)

Brad
bdavy@fred.net               http://www.fred.net/bdavy/home.html
bdavy@nox.cs.du.edu