Re: atm Going to well?

Mel Bartels (mbartels@efn.org)
Thu, 3 Aug 1995 16:54:47 -0700 (PDT)

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Dean Jansa: "atm Costs?"
Previous message: Francis J. O'Reilly: "atm Cold"
In reply to: Ken Lowther: "atm Going to well?"

If you are within 1/2" of outer edge and within foot of radius of curvature, then I would suggest going onto 120 grit. 60 and 80 grit leaves gargantuan pits to remove, plus subsurface damage that is not apparent.

Next message: Dean Jansa: "atm Costs?"
Previous message: Francis J. O'Reilly: "atm Cold"
In reply to: Ken Lowther: "atm Going to well?"