[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] pressing and glueing a wooden disk

To: <atm@atmlist.net>
Subject: Re: [ATM] pressing and glueing a wooden disk
From: "Arjan te Marvelde" <arjan.te.marvelde@hetnet.nl>
Date: Tue, 14 Aug 2007 12:13:20 +0200
Delivered-to: atm_arc@astro.umsystem.edu
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
References: <Pine.LNX.4.44.0708141124400.20645-100000@uno.canit.se>
Sender: atm-bounces@atmlist.net

> available). I got pissed off that the company that sells that
> charges about 300 USD to deliver it. The disk shown in the pics

That much? You're near Stockholm, IIRC?

> job, so I may well go get myself some plywood next weekend (using

I think that even plywood will warp a little. Mel uses 6 layers of 3/4",
according to his webpage:
http://www.bbastrodesigns.com/largthin.html#POLISHTOOL

OK, his tool is 30" diameter, but in your case I'd still take three.

   Arjan

_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- Re: [ATM] pressing and glueing a wooden disk
  - From: Dominic-Luc Webb <dlwebb@canit.se>

Prev by Author: Re: [ATM] pressing and glueing a wooden disk
Next by Author: Re: [ATM] Plans
Previous by thread: Re: [ATM] pressing and glueing a wooden disk
Next by thread: Re: [ATM] Quartz test
Index(es):
- Author
- Thread