[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: [ATM] Stubborn TDE

To: <desteinhauer@verizon.net>, <atm@atmlist.net>
Subject: Re: [ATM] Stubborn TDE
From: "Jerry" <wa4guu@verizon.net>
Date: Thu, 31 Aug 2006 16:03:41 -0400
Delivered-to: atm_arc@astro.umsystem.edu
Importance: Normal
In-reply-to: <3569369.520101157051525880.JavaMail.root@vms073.mailsrvcs.net>
List-archive: <http://www.atmlist.net/pipermail/atm>
List-help: <mailto:atm-request@atmlist.net?subject=help>
List-id: The Amateur Telescope Makers List <atm.atmlist.net>
List-post: <mailto:atm@atmlist.net>
List-subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=subscribe>
List-unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>, <mailto:atm-request@atmlist.net?subject=unsubscribe>
Sender: atm-bounces@atmlist.net

Keeping it trimmed smaller is probably causing some of the tde.

Jerry




-----Original Message-----
From: desteinhauer@verizon.net
 

Mike,

Since I started working
on the TDE, I've been very careful to keep the edge of
the lap trimmed so it is smaller than the mirror.  Not
being so careful early on in polishing is one of the 
things I suspect might have caused the initial TDE.

David
_______________________________________________


_______________________________________________
ATM mailing list http://www.atmlist.net/

Follow-Ups:
- Re: [ATM] Stubborn TDE
  - From: David Steinhauer <desteinhauer@verizon.net>

References:
- Re: [ATM] Stubborn TDE
  - From: <desteinhauer@verizon.net>

Prev by Author: Re: [ATM] Stubborn TDE
Next by Author: Re: [ATM] Polishing/figuring not going anywhere.
Previous by thread: Re: [ATM] Stubborn TDE
Next by thread: Re: [ATM] Stubborn TDE
Index(es):
- Author
- Thread