Re: [ATM] Making blanks round

["Mutalib Abdallah" <omegatroid@hotmail.com>]

edging machines as you describe are available at CRL in Los Angeles.


>From: "Bob May" <bobmay@nethere.com>
>To: <atm@atmlist.net>
>Subject: Re: [ATM] Making blanks round
>Date: Fri, 4 Aug 2006 16:58:10 -0700
>
>I've done a few blanks by the spin them and rub the side method
>that the oldimers did.  I haven't built a centerless grinder but
>I may in the future if I find a need.  For doing glasswork, I'd
>make two rollers (I think that the fixed rubbing block would be
>better done as a steel roller) and put a diamond grinder outside
>of the two rollers.  I'd also do a set of rollers to keep the
>disc upright on the grinding part just to make sure and make the
>roolers sprung as well as adjustable to make sure that the angle
>stays constant.
>Bob May
>bobmay at nethere.com
>http: slash /nav.to slash bobmay
>http: slash /bobmay dot astronomy.net
>Replace the obvious words with the proper character.
>
>_______________________________________________
>ATM mailing list http://www.atmlist.net/


_______________________________________________
ATM mailing list http://www.atmlist.net/